Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterHow Much Does Garage Door Installation Cost in Los Angeles?
A new garage door installation in Los Angeles typically runs $825 to $2,595, including the door and standard hardware. That covers a basic single-car steel door on the low end and a larger insulated or custom section door on the high end. Most single-family homes in Los Angeles land somewhere around $1,200 to $1,800 once the opener and old-door haul-away are folded in.
We’re Marlow Garage Door Repair, founded in 2002 and part of the Relay Home Co. family. We give you a written price before any wrench turns, so the number you agree to is the number on your invoice. For a Los Angeles project, you can see how we work or book online and watch your tech’s arrival time update live.
Garage Door Installation Cost Breakdown (2026)
Here’s what Los Angeles homeowners actually pay, line by line. These ranges reflect the LA market as of 2026, factoring in local labor rates and the door sizes common to homes here.
| Line item | Typical LA price range |
|---|---|
| New door installation (door + hardware + labor) | $825 – $2,595 |
| Opener installation | $295 – $650 |
| Panel replacement | $295 – $590 |
| Opener repair | $140 – $380 |
| Track realignment | $140 – $285 |
| Roller replacement | $130 – $260 |
| Spring repair | $210 – $400 |
| Cable repair | $155 – $295 |
If you’re only replacing the door and reusing your opener and tracks, you’ll sit at the lower half of that $825 to $2,595 range. Add a new opener, new rollers, and a full track swap, and you’ll climb toward the top. Old-door removal and disposal usually adds a bit, since hauling a 200-pound steel door out of a Los Angeles driveway takes a truck and a permit-friendly dump run.
To understand how installation compares to fixing what you have, it helps to know the Garage Door Installation in Los Angeles process start to finish.
What Affects Garage Door Installation Pricing in Los Angeles
- Door material and size. A standard 8×7 steel door costs far less than a 16×7 insulated carriage-house door. Custom widths for older Los Angeles garages (common in bungalows built between 1910 and 1940) push the number up because the opening isn’t standard.
- Insulation. Uninsulated single-layer steel sits at the bottom of the range. Triple-layer doors with polyurethane cores, which matter in the San Fernando Valley where summer attic temps bake the whole structure, cost noticeably more.
- Opener type. A basic chain-drive opener runs cheap. Belt-drive or smart openers with Wi-Fi, which pair naturally with the LiftMaster and Chamberlain units we install, land near the top of the $295 to $650 opener range.
- Permits. The City of Los Angeles Department of Building and Safety generally requires a permit for structural changes to a garage opening, and some neighborhoods under HPOZ (Historic Preservation Overlay Zone) review door design before approval. That review can add time and a fee to your project.
- Access and parking. Tight hillside driveways in areas like Silver Lake and Highland Park slow a two-person install crew. Steep lots off Mulholland Drive can mean extra rigging time.
- Old-door haul-away and disposal. Many LA homes have a second detached garage. If we’re pulling two doors, disposal and labor roughly double, even if only one new door goes in.
Installation Cost vs Repair Cost: When to Replace
A repair usually costs less than half of a full installation. If your door needs a spring fix at $210 to $400 or a cable repair at $155 to $295, repairing almost always makes more sense than replacing. But when the panels are dented beyond straightening, the tracks are bent from a car bump, or the door is 15 to 20 years old and the opener keeps failing, replacement is the smarter long-term move.
A quick rule: if the repair estimate climbs past about half the cost of a new door, replace it. We’ll tell you which side of that line you’re on before we quote the job.
How Long Does Garage Door Installation Take in Los Angeles?
A standard single-door replacement takes about three to five hours with a two-person crew. A double-door replacement usually runs four to six hours. Adding a new opener or new tracks extends that by roughly an hour. We give you a live arrival window you can track, so you’re not waiting in a four-hour block wondering when the truck shows up.
Here’s how a typical install at your Los Angeles home goes:
- Measure and confirm. We measure the opening, header height, and side clearance, then confirm the door size and any HPOZ or permit requirements for your address.
- Remove the old door. The old door, tracks, and hardware come down and get loaded for disposal. This is the loudest part of the day.
- Install the new tracks and brackets. New vertical and horizontal tracks go up level and plumb. Reusing old bent tracks is a common shortcut we don’t take.
- Set the torsion spring and door sections. The torsion spring, the horizontal coil above the door that does most of the lifting, gets tensioned and balanced so the door moves with one hand.
- Mount the opener and wire it. We install and program your opener, set the safety sensors, and pair it to your phone if it’s a smart unit.
- Test and show you. We cycle the door multiple times, check the balance and travel limits, then walk you through it and send before-and-after photos plus a digital invoice you pay from a link.
One safety note worth stating plainly: tensioning a torsion spring is genuinely dangerous. Those springs store enough energy to break bones or worse, and we never recommend a homeowner handling that step. Our technicians are background-checked, uniformed, and trained on eight major brands (LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor), so the person arriving already knows your specific door.
How to Save on Garage Door Installation
- Reuse what’s still good. If your opener is under eight years old and works fine, keep it. That alone can save you hundreds on the $295 to $650 opener line.
- Bundle the repair with the install. If you need track realignment ($140 to $285) or roller replacement ($130 to $260) anyway, having it done during installation can be cheaper than a separate service call.
- Pick standard sizes. Non-standard openings cost more in labor and materials. If your garage was built to a standard 16×7 or 8×7 opening, staying with it keeps you in the lower half of the range.
- Get the written price before work starts. A locked-in number beats a phone estimate every time. That’s the whole point of upfront pricing, and it’s how we run every job.
- Ask about the 365-Day Done Right Promise. If anything fails within a year, the repair is covered by a free second visit. That’s a full year of coverage in writing, not fine print.
Free estimates are standard at Marlow. Call (512) 883-4374 and a live person answers, 24 hours a day, 7 days a week. No voicemail, no callback queue.
How Much Does a New Garage Door Cost in Los Angeles?
A new garage door in Los Angeles costs $825 to $2,595 installed. Single-car steel doors start near the bottom of that range. Double-car insulated doors with smart openers sit near the top.
If you want the exact number for your door, we’ll measure your opening and send a written quote. Estimates are free and there’s no pressure to book on the spot.
FAQs – Garage Door Installation Cost
How much does garage door installation cost in Los Angeles in 2026?
It runs $825 to $2,595, depending on door size, material, and opener. Most single-car installs land around $1,200 to $1,800 with labor and haul-away included. Call (512) 883-4374 for a free written estimate for your specific opening.
Is it cheaper to repair or replace my garage door?
Repairs almost always cost less. A spring repair runs $210 to $400 and a cable repair $155 to $295, both far below a new door. If your repair estimate tops half the cost of a full replacement, replacing usually makes more sense. We’ll give you both numbers so you can decide.
Can you install a new garage door the same day?
Often yes, for standard-sized doors we stock. Most single-door installs take three to five hours. If your opening is custom or your home sits in an HPOZ area needing design review, it may take longer for permits. Call (512) 883-4374 and we’ll tell you the soonest realistic date.
Do I need a permit to install a garage door in Los Angeles?
Usually yes if the work changes the structural opening, and HPOZ neighborhoods add a design review step. Permit fees and review time add to your project cost, so budget for it up front. We’ll flag permit needs when we quote the job.
What does installation include?
The $825 to $2,595 range typically covers the new door, tracks, brackets, spring, hardware, and labor, plus old-door haul-away. Opener installation ($295 to $650) is often quoted separately. Every Marlow install is backed by the 365-Day Done Right Promise, with a written price locked before we start. Call (512) 883-4374 to book.
Pricing reflects the Los Angeles market as of 2026. Marlow Garage Door Repair offers free estimates – call (512) 883-4374.
Written by Jaylen Ross, Owner at Marlow Garage Door Repair, serving Los Angeles since 2002.
What Our Customers Say
"Quote came by text before the visit and didn't change."
- Holly T."Good repair and easy booking. The ETA slipped by about 20 minutes, but the text updated before I even noticed."
- Dave M."Opener remote stopped working. He reprogrammed it and replaced the battery contacts. Paid by link on my phone."
- Latoya S.